Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 724)

Brocade Mobility RFS Controller CLI Reference Guide 711
53-1003098-01
7
data-rates Reset radio data rate configuration to default
description Reset the description of the radio to its
default
dfs-rehome Stay on dfs elected channel after evacuation
period expires
dynamic-chain-selection Use the configured transmit antenna mode for all
clients
ekahau Use Default Ekahau Multicast MAC Address
extended-range Reset extended range to default
guard-interval Configure default value of 802.11n guard
interval (long: 800nSec)
ldpc Configure support for Low Density Parity Check
Code
lock-rf-mode Allow smart-rf to change rf-mode setting for
this radio
max-clients Maximum number of wireless clients allowed to
associate
mesh Disable mesh mode operation of the radio
meshpoint Disable a meshpoint from this radio
non-unicast Configure handling of non-unicast frames
off-channel-scan Disable off-channel scanning on the radio
placement Reset the placement of the radio to its default
power Reset the transmit power of this radio to
default
preamble-short Disable the use of short-preamble on this radio
probe-response Configure transmission parameters for Probe
Response frames
radio-resource-measurement Configure support for 802.11k Radio Resource
Measurement
radio-share-mode Configure the radio-share mode of operation for
this radio
rate-selection Monotonic rate selection
rf-mode Reset the RF mode of operation for this radio to
default (2.4GHz on radio1, 5GHz on radio2,
sensor on radio3)
rifs Configure Reduced Interframe Spacing (RIFS)
parameters
rts-threshold Reset the RTS threshold to its default (65536)
shutdown Re-enable the selected interface
sniffer-redirect Disable capture and redirection of packets
stbc Configure Space-Time Block Coding (STBC)
parameters
use Set setting to use
wireless-client Configure wireless client related parameters
wlan Disable a wlan from this radio
service Service Commands
rfs7000-37FABE(config-profile-ap71xxTest-if-radio1)#
The following example shows radio interface settings before the ‘no’ commands
are executed:
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
description Primary\ radio\ to\ use
channel 1
data-rates b-only
mesh client