Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 811)

798 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
vrrp <1-255> timers advertise [<1-255>|centiseconds <25-4095>|msec <250-999>]
vrrp version [2|3]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#vrrp version 3
rfs7000-37FABE(config-profile-default-rfs7000)#vrrp 1 sync-group
rfs7000-37FABE(config-profile-default-rfs7000)#vrrp 1 delta-priority 100
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
......................................................
vrrp 1 timers advertise 1
vrrp 1 preempt
vrrp 1 sync-group
vrrp 1 delta-priority 100
vrrp version 3
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
wep-shared-key-auth
Profile Config Commands
Enables support for 802.11 WEP shared key authentication
Supported in the following platforms:
vlan <1-4094> Optional. Enables VLAN (switched virtual interface) interface monitoring
•
<1-4094> – Specify the VLAN interface ID from 1- 4094.
wwan1 Optional. Enables Wireless WAN interface monitoring
vrrp <1-255> Configures the virtual router ID from 1- 255. Identifies the virtual router the packet is reporting status for.
timers Configures the timer that runs every interval
advertise
[<1-255>|
centiseconds <25-4095>|
msec <250-999>] Configures the VRRP advertisements time interval. This is the interval a master sends out advertisements
on each of its configured VLANs.
•
<1-255> – Configures the timer interval from 1- 255 seconds. (applicable for VRRP version 2 only)
•
centiseconds <25-4095> – Configures the timer interval in centiseconds (1/100th of a second).
Specify a value between 25 - 4095 centiseconds (applicable for VRRP version 3 only)
•
msec <250-999> – Configures the timer interval in milliseconds (1/1000th of a second). Specify a
value between 250 - 999 msec (applicable for VRRP version 2 only)
Default is 1 second.
vrrp version [2|3] Configures one of the following VRRP versions:
•
2 – VRRP version 2 (RFC 3768)
•
3 – VRRP version 3 (RFC 5798 only IPV4) (default setting)
The VRRP version determines the router redundancy. Version 3 supports sub-second (centisecond) VRRP
failover and support services over virtual IP.
no Reverts VRRP settings