Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1078)

Brocade Mobility RFS Controller CLI Reference Guide 1069
53-1003098-01
17
no
radius-user-pool-policy
Negates a command or sets its default. When used in the RADIUS user pool policy mode, the
no
command deletes a user from a RADIUS user pool
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no user
Parameters
no user
Example
The following example shows the RADIUS user pool ‘testuser’ settings before
the ‘no’ command is executed:
rfs7000-37FABE(config-radius-user-pool-testuser)#show context
radius-user-pool-policy testuser
user testuser password 0 motorolasol@123 group test1 guest expiry-time 13:20
expiry-date 12:25:2013 start-time 17:00 start-date 01:05:2013
rfs7000-37FABE(config-radius-user-pool-testuser)#
rfs7000-37FABE(config-radius-user-pool-testuser)#no user testuser
The following example shows the RADIUS user pool ‘testuser’ settings after the
‘no’ command is executed:
rfs7000-37FABE(config-radius-user-pool-testuser)#show context
radius-user-pool-policy testuser
rfs7000-37FABE(config-radius-user-pool-testuser)#
Related Commands:
user Deletes a RADIUS user
•
– Specify the user name.
user Configures the RADIUS user parameters