Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 665)

652 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
dscp 20
failover interval 200 retry 5
rfs4000-229D58(config-device 00-23-68-22-9D-58-gre-tunnel-testGRETunnel)#
Related Commands:
http-analyze
Profile Config Commands
Enables HTTP analysis on this profile. Use this command to configure the mode and interval at
which data is sent to the controller (running the HTTP analytics engine).
In the Mobility 5.5 hierarchically organized network, HTTP analytics data forwarding is a simple and
transparent process. The site controllers (Brocade Mobility RFS4000, Brocade Mobility RFS6000,
Brocade Mobility RFS7000) receive the HTTP data from adopted APs adopted. This data is
compressed and forwarded to the Network Operations Center (NOC) controller. The NOC controller
caches, formats, and uploads this information to the external analytics engine. There is no need for
a separate configuration to enable this feature.
For more information on the hierarchically network, see device-upgrade .
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
Syntax:
http-analyze [compress|update-interval <1-3600>]
Parameters
http-analyze [compress|update-interval <1-3600>]
Example
rfs7000-37FABE(config-profile-default-rfs7000)#http-analyze compress
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#http-analyze update-interval
200
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
no Removes the GRE tunnel settings based on the parameters passed
http-analyze Configures HTTP analysis parameters. These parameters are: compress and update-interval.
compress Compresses update files before forwarding to the controller. This option is disabled by default.
update-interval
<1-3600> Sets the interval, in seconds, at which buffered packets are pushed to analyze the HTTP connection
•
<1-3600> – Specify the interval from 1 - 3600 seconds. The default is 60 seconds.