Smart-rf-policy – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1134
1126
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
•
If no SMART RF policy is mapped, the radio selects a random channel
If the radio is a dedicated sensor, it stops termination on that channel if a neighboring access point
detect radar. The access point attempts to come back to its original channel (statically configured
or selected by Smart RF) after the channel evacuation period has expired.
Change this behavior using the
command from the controller or service platform CLI.
This keeps the radio on the newly selected channel and prevents the radio from coming back to the
original channel, even after the channel evacuation period.
NOTE
Perform RF planning to ensure overlapping coverage exists at a deployment site, for Smart RF to be
a viable network performance tool. Smart RF can only provide recovery when access points are
deployed appropriately. Smart RF is not a solution, it is a temporary measure. You need to determine
the root cause of RF deterioration and fix it. Smart RF history/events can assist in trouble shooting.
Use the (config) instance to configure Smart RF Policy related configuration commands. To
navigate to the Smart RF policy instance, use the following commands:
rfs7000-37FABE(config)#smart-rf-policy test
rfs7000-37FABE(config-smart-rf-policy-test)#?
Smart RF Mode commands:
area Specify channel list/ power for an area
assignable-power Specify the assignable power during power-assignment
channel-list Select channel list for smart-rf
channel-width Select channel width for smart-rf
coverage-hole-recovery Recover from coverage hole
enable Enable this smart-rf policy
group-by Configure grouping parameters
interference-recovery Recover issues due to excessive noise and
interference
neighbor-recovery Recover issues due to faulty neighbor radios
no Negate a command or set its defaults
sensitivity Configure smart-rf sensitivity (Modifies various
other smart-rf configuration items)
smart-ocs-monitoring Smart off channel scanning
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-smart-rf-policy-test)#
smart-rf-policy