L2tpv3-policy-commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1198
1190
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
NOTE
If connecting an Ethernet port to another Ethernet port, the pseudowire type must be Ethernet port,
if connecting an Ethernet VLAN to another Ethernet VLAN, the pseudowire type must be Ethernet
VLAN.
This chapter is organized into the following sections:
•
•
•
l2tpv3-manual-session-commands
l2tpv3-policy-commands
Use the (config) instance to configure L2TPv3 policy parameters. To navigate to the L2TPv3 policy
instance, use the following commands:
rfs7000-37FABE(config)#l2tpv3 policy L2TPV3Policy1
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#
rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#?
L2tpv3 Policy Mode commands:
cookie-size Size of the cookie field present in each l2tpv3 data
message
failover-delay Time interval for re-establishing the tunnel after
the failover (RF-Domain
manager/VRRP-master/Cluster-master failover)
force-l2-path-recovery Enables force learning of servers, gateways etc.,
behind the l2tpv3 tunnel when the tunnel is
established
hello-interval Configure the time interval (in seconds) between
l2tpv3 Hello keep-alive messages exchanged in l2tpv3
control connection
no Negate a command or set its defaults
reconnect-attempts Maximum number of attempts to reestablish the
tunnel.
reconnect-interval Time interval between the successive attempts to
reestablish the l2tpv3 tunnel
retry-attempts Configure the maximum number of retransmissions for
signaling message
retry-interval Time interval (in seconds) before the initiating a
retransmission of any l2tpv3 signaling message
rx-window-size Number of signaling messages that can be received
without sending the acknowledgment
tx-window-size Number of signaling messages that can be sent
without receiving the acknowledgment
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes