Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 622
Brocade Mobility RFS Controller CLI Reference Guide
609
53-1003098-01
7
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-cryptomap-map1#1)#
The following table summarizes crypto map configuration mode commands.
crypto-map auto-vpn-tunnel/remote-vpn-client instance
To navigate to the auto site-to-site VPN tunnel configuration instance, use the following command:
In the device-config mode:
ipsec-isakmp
In the profile-config mode:
ipsec-isakmp
rfs4000-229D58(config-device-00-23-68-22-9D-58)#crypto map test 1 ipsec-isakmp
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#1)#?
Site to Site Crypto Map Configuration commands:
ip Internet Protocol config commands
local-endpoint-ip Use this IP as local tunnel endpoint address, instead
of the interface IP (Advanced Configuration)
no Negate a command or set its defaults
peer Add a remote peer
pfs Specify Perfect Forward Secrecy
security-association Security association parameters
transform-set Specify IPSec transform to use
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
Command
Description
Reference
crypto-map
auto-vpn-tunnel/re
mote-vpn-client
instance
Configures an auto site-to-site VPN or remote VPN client
crypto-map-ipsec-m
anual-instance
Configures a manual site-to-site VPN