Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 508)

494 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
Parameters
show pppoe-client [configuration|status] {on }
Example
rfs7000-37FABE(config)#show pppoe-client configuration
PPPoE Client Configuration:
+-------------------------------------------
| Mode : Disabled
| Service Name :
| Auth Type : pap
| Username :
| Password :
| Idle Time : 600
| Keepalive : Disabled
| Local n/w : vlan1
| Static IP : 0.0.0.0
| MTU : 1492
+-------------------------------------------
rfs7000-37FABE(config)#
privilege
show commands
Displays a device’s existing privilege level
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show privilege
Parameters
None
Example
rfs7000-37FABE(config)#show privilege
Current user privilege: superuser
pppoe-client Displays PPPoE client information (configuration and status)
configuration Displays detailed PPPoE client configuration
status Displays detailed PPPoE client status
on The following keywords are common to ‘configuration’ and ‘status’ parameters:
•
on – Optional. Displays detailed PPPoE client status or configuration on a specified
device
•
– Specify the name of the AP, wireless controller, or service platform.