Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 767)

754 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
Parameters
l3e-lite-table aging-time <10-1000000>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#l3e-lite-table aging-time 1000
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
..........................................................
interface ge4
ip dhcp trust
qos trust dscp
qos trust 802.1p
interface pppoe1
use firewall-policy default
l3e-lite-table aging-time 1000
--More--
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
led
Profile Config Commands
Turns on and off access point LEDs
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
led {flash-pattern}
Parameters
aging-time
<10-1000000> Configures the aging time in seconds. The aging time defines the duration a learned L3e entry (IP, VLAN)
remains in the L3e Lite table before deletion due to lack of activity.
no Removes the L3e lite table aging time configuration