Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1055)

1046 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
17
Related Commands:
no
radius-group
Negates a command or sets its default. Removes or modifies the RADIUS group policy settings.
When used in the config RADIUS group mode, the
no
command removes or modifies the following
settings: access type, access days, role type, VLAN ID, and SSID.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [guest|policy|rate-limit]
no policy [access|day|role|ssid|time|vlan]
no policy access [all|console|ssh|telnet|web]
no policy day [all|fr|mo|sa|su|th|tu|we|weekdays]
no policy ssid [|all]
no policy [role|time|vlan]
no rate-limit [from-air|to-air]
Parameters
no guest
no policy access [all|console|ssh|telnet|web]
no Removes the RADIUS guest group’s rate limits
no guest Makes a RADIUS guest group a non-guest (management) group
no policy access Removes or modifies the RADIUS management group access
•
all – Removes all access (Wireless client access to the console, SSH, Telnet, and Web)
•
console – Removes console access
•
ssh – Removes SSH access
•
telnet – Removes Telnet
•
web – Removes Web access
These are recursive options, and you can remove more than one at a time.