Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1156)

1148 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
21
br-detection {age-out <30-86400>|wait-time <10-600>}
Example
rfs7000-37FABE(config-wips-policy-test)#br-detection wait-time 15
rfs7000-37FABE(config-wips-policy-test)#br-detection age-out 50
rfs7000-37FABE(config-wips-policy-test)#show context
wips-policy test
br-detection-ageout 50
br-detection-wait-time 15
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
enable
wips-policy
Enables this WIPS policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
enable
Parameters
None
Example
rfs7000-37FABE(config-wips-policy-test)#enable
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
age-out
<30-86400> Optional. Configures the unauthorized AP ageout interval. The WIPS policy uses this value to ageout
unauthorized APs.
•
<30-86400> – Sets an ageout interval from 30 - 86400 seconds. The default is 5 minutes (300
seconds).
wait-time
<10-600> Optional. Configures the wait time before a detected AP is declared as unauthorized and potentially
removed
•
<10-600> – Sets a wait time from 10 - 600 seconds. The default is 1 minute (60 seconds).
no Resets unauthorized or unsanctioned AP detection settings to default
no Disables a WIPS policy