Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 486)

472 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
nx6500-31FABE(config)#
ip
show commands
Displays IP related information
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show ip [arp|ddns|default-gateways|dhcp|dhcp-vendor-options|domain-name|igmp|
interface|name-server|nat|ospf|route|routing]
show ip arp {} {(on )}
show ip ddns bindings {on }
show ip dhcp [binding|networks|status]
show ip dhcp binding {manual} {(on )}
show ip dhcp [networks|status] {on }
show ip
[default-gateways|dhcp-vendor-options|domain-name|name-server|routing]
{on }
show ip igmp snooping [mrouter|vlan]
show ip igmp snooping mrouter vlan <1-4095> {on }
show ip igmp snooping vlan <1-4095> {} {(on )}
show ip interface {|brief|on}
show ip interface {|brief} {(on )}
show ip nat translations verbose {on }
show ip route {|ge|me1|on|port-channel|pppoe1|vlan|wwan1}
show ip route {|ge <1-4>|me1|port-channel <1-2>|vlan <1-4094>|
pppoe1|wwan1} {(on )}
show ip ospf {border-router|interface|neighbor|on|route|state}
show ip ospf {border-router|neighbor|route|on|state} {on }
show ip ospf {interface} {vlan|on}
show ip ospf {interface} {vlan <1-4094>} {(on )}
NOTE
The show ip ospf command is also available under the ‘profile’ and ‘device’ modes.
Parameters