Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 453)

Brocade Mobility RFS Controller CLI Reference Guide 439
53-1003098-01
6
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show boot {on }
Parameters
show boot {on }
Example
rfs4000-229D58(config)#show boot
-----------------------------------------------------------------------------
---
IMAGE BUILD DATE INSTALL DATE VERSION
-----------------------------------------------------------------------------
---
Primary 04:09:2013 12:40:41 04:10:2013 09:10:05 5.5.0.0-034B
Secondary 03:31:2013 02:46:47 04:04:2013 10:45:00 5.5.0.0-030D
-----------------------------------------------------------------------------
---
Current Boot : Primary
Next Boot : Primary
Software Fallback : Enabled
rfs4000-229D58(config)#
captive-portal
show commands
Displays WLAN captive portal information. Use this command to view a configured captive portal’s
client information.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
boot Displays primary and secondary image boot configuration details (build date, install date, version, and the
image used to boot the current session)
on Optional. Displays a specified device’s boot configuration
•
– Specify the name of the AP, wireless controller, or service platform.
NOTE: Use the on option to view a remote device’s boot configuration.