Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1090)

1082 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
18
smart-aggregation {min-aggregation-limit <0-64>}
Example
rfs7000-37FABE(config-radio-qos-test)#smart-aggregation delay voice 50
rfs7000-37FABE(config-radio-qos-test)#smart-aggregation delay background 100
rfs7000-37FABE(config-radio-qos-test)#show context
radio-qos-policy test
smart-aggregation delay voice 50
smart-aggregation delay background 100
rfs7000-37FABE(config-radio-qos-test)#
Related Commands:
service
radio-qos-policy
Invokes service commands in the radio QoS configuration mode
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
service [admission-control|show]
service admission-control across-reassoc
service show cli
Parameters
service admission-control across-reassoc
service show cli
min-aggregation-limit
<0-64> Optional. Sets the minimum number of aggregates buffered before an aggregate is sent
•
<0-64> – Specify a value from 0 - 64. The default is 8 frames.
no Resets the minimum aggregation limit
service Invokes service commands
admission-control
across-reassoc Retains previously negotiated TSPEC parameters across re-associations on the radio
For more information on admission-control parameters, see
admission-control .
service show cli Displays running system information
•
cli – Displays the Radio QoS mode’s CLI tree