Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 718)

Brocade Mobility RFS Controller CLI Reference Guide 705
53-1003098-01
7
Syntax:
guard-interval [any|long]
Parameters
guard-interval [any|long]
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#guard-interval long
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
description Primary\ radio\ to\ use
channel 1
data-rates b-only
beacon period 50
beacon dtim-period bss 1 5
beacon dtim-period bss 2 2
beacon dtim-period bss 3 5
beacon dtim-period bss 4 5
beacon dtim-period bss 5 5
beacon dtim-period bss 6 5
beacon dtim-period bss 7 5
beacon dtim-period bss 8 5
beacon dtim-period bss 9 5
beacon dtim-period bss 10 5
beacon dtim-period bss 11 5
beacon dtim-period bss 12 5
beacon dtim-period bss 13 5
beacon dtim-period bss 14 5
beacon dtim-period bss 15 5
beacon dtim-period bss 16 5
antenna-gain 12.0
guard-interval long
--More--
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
ldpc
interface-config-radio-instance
Enables support for Low Density Parity Check (LDPC) on the radio interface.
LDPC consists of forward error correcting codes that enable error control in data transmission.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
any Enables the radio to use any short (400nSec) or long (800nSec) guard interval
long Enables the use of long guard interval (800nSec). This is the default setting.
no Resets the 802.11n guard interval to default (long: 800nSec)