Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 84)

66 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
Installing third-party VMs saves on hardware cost and provides a unified VM management
interface.
• Syntax Brocade Mobility RFS9510
Supported in the following platforms:
• Service Platforms — Brocade Mobility RFS9510
virtual-machine assign-usb-ports team-vowlan {on }
virtual-machine console [|team-urc|team-rls|team-vowlan]
virtual-machine export [|] {on }
assign-usb-ports
team-vowlan Assigns USB ports to TEAM-VoWLAN on a specified device
•
on – Optional. Specify the device name.
Use the
no > virtual-machine > assign-usb-ports
to reassign the port to Mobility.
TEAM-RLS VM cannot be installed when USB ports are assigned to TEAM-VoWLAN.
virtual-machine console Connects to the VM’s console, based on the parameters passed. Select one of the following console
options:
•
– Connects to the console of the VM identified by the keyword. Specify the
VM name.
•
team-urc – Connects to the VM TEAM Unified Retail Communication’s (URC) (IP-PBX) console
•
team-rls – Connects to the VM TEAM Radio Link Service (RLS) server’s console
•
team-vowlan – Connects to the VM TEAM-VoWLAN’s (Voice over WLAN) console
virtual-machine export Exports an existing VM image and settings. Use this command to export the VM to another NX45XX or
device in the same domain.
•
– Specify the VM name.
•
– Specify the location and name of the source file (VM image). The VM image is retrieved
and exported from the specified location.
•
– Specify the destination location. This is the location to which the VM image is
copied. Use one of the following formats to provide the destination path:
tftp://[:port]/path/file
ftp://:@[:port]/path/file
sftp://:@[:port]>/path/file
http://[:port]/path/file
•
on – Optional. Executes the command on a specified device or devices
•
– Specify the service platform name. In case of multiple devices,
list the device names separated by commas.
The VM should be in a stop state during the export process.
If the destination is a device, the image is copied to a predefined location (VM archive)