Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 151)

134 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
drwx Sat Jan 1 00:00:08 2000 cache
drwx Wed Jan 16 22:26:53 2013 crashinfo
drwx Fri Feb 15 14:50:49 2013 testdir
drwx Wed Jan 16 22:57:14 2013 archived_logs
drwx Sat Jan 1 00:00:08 2000 upgrade
drwx Sat Jan 1 00:00:09 2000 hotspot
drwx Sat Jan 1 00:00:09 2000 floorplans
drwx Sat Jan 1 00:00:09 2000 startuplog
-rw- 176128 Fri Feb 15 14:32:51 2013 out.tar
rfs4000-229D58#
re-elect
Privileged Exec Mode Commands
Re-elects the tunnel controller (wireless controller or service platform)
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
re-elect tunnel-controller { {on }|on }
Parameters
re-elect tunnel-controller { {on }|on }
Example
rfs7000-37FABE#re-elect tunnel-controller
OK
rfs7000-37FABE#
reload
Privileged Exec Mode Commands
Halts the device and performs a warm reboot
Supported in the following platforms:
re-elect
tunnel-controller Re-elects the tunnel controller
{on } Optional. Re-elects the tunnel controller on all devices whose preferred tunnel controller name matches
•
on – Optional. Re-elects the tunnel controller on a specified device
•
– Specify the name of the AP, wireless controller, or service platform.