Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 694)

Brocade Mobility RFS Controller CLI Reference Guide 681
53-1003098-01
7
Negates a command or reverts to defaults. The no command, when used in the Config Interface
VLAN mode, negates VLAN interface settings or reverts them to their default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [crypto|description|dhcp-relay-incoming|ip|shutdown|use]
no [crypto map|description|dhcp-relay-incoming|shutdown|use
in]
no ip [address|dhcp|helper-address|nat|ospf]
no ip [helper-address |nat]
no ip address [ {secondary}|dhcp|zerconf {secondary}]
no ip dhcp client request options all
no ip ospf
[authentication|authentication-key|bandwidth|cost|message-digest-key|
priority]
Parameters
no [crypto map|description|dhcp-relay-incoming|shutdown|use
in]
no ip address [ {secondary}|dhcp|zerconf {secondary}]
no crypto map Disassociates a crypto map from an interface
no description Removes the VLAN interface description
no dhcp-relay-incoming Prevents an onboard DHCP server from responding to relayed DHCP packets
no shutdown Enables an interface
If an interface has been shutdown, use the no shutdown command to enable the interface. Use this
command to trouble shoot new interfaces.
no use
in Removes specified IP access list from use by an interface
•
in – Disables incoming packets
•
– Specify the IP access list name.
no ip address Removes or reverts interface IP settings
•
address – Removes IP addresses configured for this interface
{secondary} Specify the interface IP address in the A.B.C.D/M format.
•
secondary – Optional. Removes the secondary IP address
dhcp Removes the IP address obtained using the DHCP client
zerconf {secondary} Removes the IP address generated using a zerconf
•
secondary – Optional. Removes the secondary IP address