Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 634)

Brocade Mobility RFS Controller CLI Reference Guide 621
53-1003098-01
7
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#no use
ip-access-list
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#no peer 1
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#no
transform-set
The following example shows the IPSec remote VPN client ‘test’ settings after
the ‘no’ commands are executed:
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#show context
crypto map test 2 ipsec-isakmp dynamic
local-endpoint-ip 157.235.204.62
pfs 14
security-association lifetime seconds 10000
remote-type none
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#2)#
crypto-map-ipsec-manual-instance
crypto-map-config-commands
To navigate to the automatic IPSec manual VPN tunnel configuration instance, use the following
command:
In the device-config mode:
(config-device-)#crypto map <1-1000>
ipsec-manual
In the profile-config mode:
(config-profile-)#crypto map <1-1000>
ipsec-manual
rfs4000-229D58(config-device-00-23-68-22-9D-58)#crypto map test 3 ipsec-manual
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#3)#?
Manual Crypto Map Configuration commands:
local-endpoint-ip Use this IP as local tunnel endpoint address, instead
of the interface IP (Advanced Configuration)
mode Set the tunnel mode
no Negate a command or set its defaults
peer Set peer
security-association Set security association parameters
session-key Set security session key parameters
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs4000-229D58(config-device-00-23-68-22-9D-58-cryptomap-test#3)#