Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 839)

826 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
gre GRE protocol
interface Select an interface to configure
ip Internet Protocol (IP)
l2tpv3 L2tpv3 protocol
l3e-lite-table L3e lite Table
led LED on the device
lldp Link Layer Discovery Protocol
location The location
logging Modify message logging facilities
mac-address-table MAC Address Table
mac-auth 802.1X
memory-profile Memory-profile
mint MiNT protocol
noc Noc related configuration
ntp Configure NTP
override-wlan Overrides for wlans
power-config Configure power mode
preferred-controller-group Controller group this system will
prefer for adoption
preferred-tunnel-controller Tunnel Controller Name this system
will prefer for tunneling extended
vlan traffic
rf-domain-manager RF Domain Manager
router Dynamic routing
routing-policy Policy Based Routing Configuration
sensor-server Motorola AirDefense WIPS sensor server
configuration
spanning-tree Spanning tree
timezone The timezone
tunnel-controller Tunnel Controller group this
controller belongs to
use Set setting to use
vrrp VRRP configuration
service Service Commands
rfs4000-229D58(config-device-00-23-68-22-9D-58)#
rsa-key
Device Config Commands
Assigns a RSA key to a device
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
rsa-key ssh
Parameters