Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 470)

456 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
Example
rfs7000-37FABE(config)#show dot1x all on rfs7000-37FABE
SysAuthControl is disabled
Guest-Vlan is disabled
AAA-Policy is none
Dot1x info for interface GE1
-----------------------------------
Supplicant MAC N/A
Auth SM State = FORCE AUTHORIZED
Bend SM State = REQUEST
Port Status = AUTHORIZED
Host Mode = SINGLE
Auth Vlan = None
Guest Vlan = None
Dot1x info for interface GE2
-----------------------------------
Supplicant MAC N/A
Auth SM State = FORCE AUTHORIZED
Bend SM State = REQUEST
Port Status = AUTHORIZED
Host Mode = SINGLE
Auth Vlan = None
Guest Vlan = None
--More--
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show dot1x interface ge 3
Dot1x info for interface GE3
-----------------------------------
Supplicant MAC N/A
Auth SM State = FORCE AUTHORIZED
Bend SM State = REQUEST
Port Status = AUTHORIZED
Host Mode = SINGLE
Auth Vlan = None
Guest Vlan = None
rfs7000-37FABE(config)#
environmental-sensor
show commands
Displays environmental sensor’s recorded data. The environmental sensor has to be enabled and
configured in order to collect data related to humidity, light, motion, and temperature.
For more information on enabling and configuring environmental sensor settings, see
environmental-sensor .
port-channel <1-2> Displays dot1x for a specified port channel interface
•
<1-2> – Select the interface index from 1 - 2.
on The following keywords are common to all of the above parameters:
•
on – Optional. Displays dot1x interface information on a specified device
•
– Specify the name of AP, wireless controller, or service platform.