Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 967)

956 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
respond-via-unicast
dhcp-pool-mode commands
Sends DHCP offer and acknowledgement as unicast messages
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
respond-via-unicast
Parameters
None
Example
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#respond-via-unicast
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#show context
dhcp-pool testPool
address 192.168.13.4 class dhcpclass1
ddns server 192.168.13.9
ddns multiple-user-class
excluded-address range 192.168.13.25 192.168.13.28
netbios-node-type b-node
dns-server 192.168.13.19
netbios-name-server 192.168.13.25
option option1 157.235.208.80
respond-via-unicast
rfs4000-229D58(config-dhcp-policy-test-pool-testPool)#
Related Commands:
static-route
dhcp-pool-mode commands
Configures a static route for a DHCP pool. Static routes define a gateway for traffic intended for
other networks. This gateway is always used when an IP address does not match any route in the
network.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
no Disables sending of a DHCP offer and DHCP Ack as unicast messages. When disabled, sends offer and
acknowledgement as broadcast messages.