Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 314)

298 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Configures the RF Domain’s physical location. The location could be as specific as the building
name or floor number. Or it could be generic and include an entire site. The location defines the
physical area where a common set of device configurations are deployed and managed by a RF
Domain policy.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
location
Parameters
location
Example
rfs7000-37FABE(config-rf-domain-default)#location SanJose
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
location SanJose
contact Bob+919621212577
country-code in
channel-list 2.4GHz 1,2,3,4,5,6,7,8,9,10
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
control-vlan 1
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
mac-name
rf-domain-mode commands
Configures a relevant name for each MAC address
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
location Configures the RF Domain location by specifying the area or building name
•
– Specify the location.
no Removes the RF Domain location