Meshpoint-device-config-instance, Meshpoint-device – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 1298
1290
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
accelerated-multicast 224.0.0.1 classification video
rfs7000-37FABE(config-meshpoint-qos-test)#rate-limit meshpoint from-air rate
80000
rfs7000-37FABE(config-meshpoint-qos-test)#rate-limit meshpoint from-air
red-threshold video 80
rfs7000-37FABE(config-meshpoint-qos-test)#rate-limit meshpoint from-air
red-threshold voice 70
rfs7000-37FABE(config-meshpoint-qos-test)#show context
meshpoint-qos-policy test
rate-limit meshpoint from-air rate 80000
rate-limit meshpoint from-air max-burst-size 800
rate-limit meshpoint from-air red-threshold video 80
rate-limit meshpoint from-air red-threshold voice 70
accelerated-multicast 224.0.0.1 classification video
rfs7000-37FABE(config-meshpoint-qos-test)#
Related Commands:
meshpoint-device-config-instance
The following table lists the meshpoint device configuration commands.
meshpoint-device
meshpoint-device-config-instance
This command configures an access point to use a defined meshpoint. This command is available
only under the Brocade Mobility 650 Access Point, Brocade Mobility 1220 Access Point, Brocade
Mobility 71XX Access Point, Brocade Mobility 1240 Access Point device or profile context. To
configure this feature use one of the following options:
•
navigate to the device profile config context (used when configuring access point profile on a
controller)
•
navigate to the device’s config context using the self command (used when configuring a
logged on access point)
Supported in the following platforms:
•
Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
•
Access Points (as root APs only) — Brocade Mobility 650 Access Point
Resets traffic rate limit settings for this meshpoint QoS policy
Command
Description
Reference
Configures an access point as a meshpoint device and enters its configuration mode
Invokes the meshpoint-device configuration commands