Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 996
924
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Layer 3 access control list policy
22
5. To add a host to the network group, complete the following steps.
a. Enter a valid host name in the Host Name field.
b. Click the right arrow button to move the host name to the Selected table.
6. To edit an address range to the network group, complete the following steps.
a. Select the range you want to edit in the Selected table and click the left arrow button.
b. Change the IP address for the start of the range in the Start field.
c. Change the IP address for the end of the range in the End field.
d. Click the right arrow button to move the address range back to the Selected table.
7. To add an address range to the network group, complete the following steps.
a. Enter an IP address for the start of the range in the Start field.
b. Enter an IP address for the end of the range in the End field.
c. Click the right arrow button to move the address range to the Selected table.
8. To add a network to the network group, complete the following steps.
a. Select one or more networks from the Networks table.
b. Click the right arrow button to move to the Selected table.
9. To add another network group to the network group, complete the following steps.
a. Select one or more network groups from the Network Groups table.
b. Click the right arrow button to move to the Selected table.
10. Click OK on the Duplicate Network Group dialog box.
The Network dialog box - Network Groups tab displays with the new network group in the List of
Network Groups table.
11. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.