Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 971)

Brocade Network Advisor SAN + IP User Manual 899
53-1003155-01
Layer 3 access control list policy
22
The updated ACL rule displays in the ACL Entries list. To update additional rules for the
same ACL, repeat
step 4 .
6. To add a new rule, complete step 5 through step 10 in “Creating a standard L3 ACL
configuration” on page 895.
The updated ACL rule displays in the ACL Entries list. To update additional rules for the same
ACL, repeat
step 5 .
7. To delete an existing rule, select the rule you want to delete in the ACL Entries list and click the
left arrow button.
8. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
9. Click Close on the L3 ACL Advanced Settings dialog box to close.
10. Click OK on the Duplicate - L3 ACL Configuration dialog box.
11. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 911.
12. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 911.
13. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.
The Deploy to Products - L3 ACL dialog box displays. To deploy the configuration, refer to
“Security configuration deployment” on page 943.
Creating an extended L3 ACL configuration
To create an extended L3 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > L3 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
2. Select New IPv4 from the Add list.
The Add - L3 ACL Configuration dialog box displays.
3. Select Extended from the Type list.