Authentication tab – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 695
Brocade Network Advisor SAN + IP User Manual
623
53-1003155-01
SMI Agent Configuration Tool
13
Authentication tab
NOTE
You must have User Management Read and Write privileges to make changes on the CIMOM tab.
For more information about privileges, refer to
The Authentication tab enables you to configure mutual authentication for Client and Indication
using a secure protocol.
Enabling or disabling CIM client and indication mutual authentication
When you enable client mutual authentication, all CIM client and indication requests to the SMI
Agent must pass credentials (KeyStore and TrustStore) to validate the requests. The KeyStore file
provides the credentials and the TrustStore file verifies the credentials. When you enable indication
mutual authentication, both the CIM client and the CIMOM server maintain the TrustStore files.
The CIM client KeyStore file sends credentials to be validated by the CIMOM server TrustStrore file
for any communication from the CIM client to the CIMOM server and the CIMOM server KeyStore
file sends credentials to be validated by the CIM client TrustStrore file for any communication from
the CIMOM server to the CIM client
To enable or disable CIM client and indication mutual authentication, complete the following steps.
1. Click the Authentication tab.
FIGURE 256
Authentication tab
2. Select the Enable Client Mutual Authentication check box, as needed.
If the check box is checked, CIM client mutual authentication is enabled. If the check box is
clear (default), client mutual authentication is disabled.
3. Select the Enable Indication Mutual Authentication check box, as needed.
If the check box is checked, indication mutual authentication is enabled. If the check box is
clear (default), indication mutual authentication is disabled.