Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 242)

172 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
SAN End node display
5
SAN End node display
The connectivity map can be configured to display or not display end nodes. This option enables
you to set the end node display for all newly discovered fabrics. Note that disabling end node
display limits the connectivity map to emphasize switch members only.
Displaying end nodes
To display end nodes when discovering a new fabric, complete the following steps.
1. Select Server > Options.
The Options dialog box displays ( Figure 64 ).
FIGURE 64 Options dialog box (SAN End Node Display pane)
2. Select SAN End Node Display in the Category list.
3. Select the Show connected end nodes when new fabric is discovered check box to display end
nodes on your system.
NOTE
Before changes can take effect, the topology must be rediscovered.
4. Click Apply or OK to save your work.
SAN Ethernet loss events
An Ethernet event occurs when the Ethernet link between the Management Server and the
managed SAN device is lost. You can configure the application to enable events when the Ethernet
connection is lost.
Enabling SAN Ethernet loss events
The Options dialog box enables you to configure the Management application to generate an
Ethernet event after a device is offline for a specific period of time.
To enable Ethernet loss events, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.