Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 270
200
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Software Configuration
5
Server impact
•
Configuration wizard (does not display all IP addresses)
•
Trap and Syslog auto registration
•
Report content (Ipconfiguration element does not display all server IP addresses)
•
Network OS configuration backup through FTP
•
Trace dump through FTP
Client impact
•
Options dialog box (does not display all IP addresses)
•
Firmware import and download dialog box
•
Firmware import for Fabric OS and Network OS products
•
FTP button in Technical Support Repository dialog box
•
Technical supportSave of Fabric OS, Network OS, and Host products through FTP
To configure the IP address used by the server for client-server communications, complete the
following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Client/Server IP in the Category list to set the IP address.
The Client/Server IP pane displays (
Figure 78
).
FIGURE 78
Options dialog box (Client/Server IP option)
3. Choose one of the following options in the Server IP Configuration list.
•
.
•
Select a specific IP address. Continue with
.
•
Select localhost. Continue with
.
When Server IP Configuration is set to All, you can select any available IP address as the
Return Address. If you select a specific IP address, the Return Address list shows the same IP
address and you cannot change it.