Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 967)

Brocade Network Advisor SAN + IP User Manual 895
53-1003155-01
Layer 3 access control list policy
22
You can create two types of ACLs:
• Standard ACL — Use to permit and deny traffic based on the source IP address, host name, or
network. You should use standard ACLs when you only need to filter traffic based the source.
You can create up to 99 standard ACLs ranging from 1 through 99. For more information, refer
to
“Creating a standard L3 ACL configuration” on page 895.
• Extended ACL — Use to permit and deny traffic based on the source and destination using the
following:
- Source and destination IP address
- Host name
- User-defined network and network groups
- IP protocol
- Source and destination port
You can create up to 100 extended ACLs ranging from 100 through 199. For more information,
refer to
“Creating an extended L3 ACL configuration” on page 899.
Creating a standard L3 ACL configuration
To create a standard L3 ACL configuration, complete the following steps.
1. Select the device and select Configure > Security > L3 ACL > Product.
The Device_Name - L3 ACL Configuration dialog box displays.
FIGURE 346 Device_Name - L3 ACL Configuration dialog box
2. Select New IPv4 from the Add list.
The Add - L3 ACL Configuration dialog box displays.