Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 2300)

2228 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
CLI Templates
G
TABLE 39 Network OS – Configure Extended L2 Access List
Feature Description CLI Commands
ACL This template is used to configure
an extended L2 ACL on Network OS
products running 3.0 or later. mac access-list extended $
deny $ $ any
deny any $ $
deny $ $ $
$
permit $ $ $
$
permit any any
TABLE 40 Network OS – Configure Inter Frame Gap Violation Fencing
Feature Description CLI Commands
Network
OS This template is used to configure
high threshold value to fence an
interface when Inter Frame
Gap(IFG) minimum length (typical
value is 12) violation occurs.
Possible values for timebase are
day, hour, minute and none. threshold-monitor interface custom type Ethernet area IFG
threshold timebase $ high-threshold
$
threshold-monitor interface custom type Ethernet area IFG
alert above highthresh-action fence
threshold-monitor interface apply custom-monitoring
TABLE 41 Network OS – Configure Inter Frame Gap Violation Monitor
Feature Description CLI Commands
Network OS This template is used to configure
threshold and alert values for Inter
Frame Gap(IFG) minimum length
(typical value is 12) Violation
monitoring.
Possible values for timebase are
day, hour, minute and none.
Buffer value cannot be more than
average of high plus low threshold.
Supported Values for High and
Low Threshold Action Parameters
are email, raslog, all, and none. threshold-monitor interface custom type Ethernet area IFG
threshold timebase $ high-threshold
$ low-threshold
$ buffer
$
threshold-monitor interface custom type Ethernet area IFG
alert above highthresh-action
$ lowthresh-action
$
threshold-monitor interface custom type Ethernet area IFG
alert below highthresh-action
$ lowthresh-action
$
threshold-monitor interface apply custom-monitoring