Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1412)

1340 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Management Module switchover
31
A warning message displays:
You want to reset the selected interface statistics. Do you want to continue?
Click Yes to clear all the statistics of the port.
FIGURE 595 Resetting port counters
Enable or Disable
Enable or disable on a module will perform module power on or off. It is applicable only to the
configuration module.
To enable or disable a port, right-click a slot (or slots), trunk (or trunks), or port (or ports) and select
Enable or Disable.
NOTE
After performing the enable or disable operation on ports or at module level, the changes will be
reflected only after the discovery of the product.
Management Module switchover
The Management Module allows you to manage all of the routing actions of a device. If there is
more than one Management Module you can make one of the modules the active module and the
other module the standby module.
NOTE
If the active Management Module fails, you must switch to the standby module.
Changing the standby Management Module to active
To change the standby Management Module to active, click Configure > MR Switch Over (as shown
in
Figure 596 ).
Or