Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1946)

1874 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Adding a configuration policy manager
47
• To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the configuration policy
manager:

To configure deployment to run only once, refer to “Configuring a one-time
configuration policy manager schedule” on page 1878.

To configure hourly deployment, refer to “Configuring an hourly configuration policy
manager schedule” on page 1879.

To configure daily deployment, refer to “Configuring a daily configuration policy
manager schedule” on page 1879.

To configure weekly deployment, refer to “Configuring a weekly configuration policy
manager schedule” on page 1879.

To configure monthly deployment, refer to “Configuring a monthly configuration policy
manager schedule” on page 1880.
6. To set configuration policy managers for fabrics, select the Fabric Checks tab and complete the
following steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
• Select the Enabled option to determine if zoning is enabled.
• Select the Disabled option to determine if zoning is disabled.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1864.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1864.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1864.
d. Select the Check zones that do not contain any online member check box to identify zones
in which all zone members are offline.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1864.
e. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 1:1 (1 initiator port to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 1:1, the configuration
policy manager considers it as a violation and logs it in the report.
f. Select the Check that all profiles are the same on each RBridge in an Ethernet fabric
check box to determine if all RBridge profiles in an Ethernet fabric are the same.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1864.
g. Select the fabrics to which you want to apply this policy in the Available Fabrics list and
click the right arrow button.