Displaying a list of vlans, Vlan management in a vcs environment – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1514
1442
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
VLAN Manager
36
Displaying a list of VLANs
To view the list of VLANs that were discovered on the network, select Configure > VLANs.
The VLAN View tab of the VLAN Manager dialog box displays.
The VLAN Manager tool bar contains the following buttons:
•
Add — Launches the Add VLAN dialog box.
•
Edit — Launches the Edit VLAN dialog box.
•
Delete — Launches the Delete VLAN dialog box.
•
STP — Allows you to configure STP, RSTP, MSTP, PVST, or RPVST information for a product, port,
or VLAN.
•
ACL — Launches the ACL Configuration dialog box, where you can assign access control lists to
a VLAN.
•
802.1ag CFM — If the Management application manages at least one of the service provider
products (NetIron XMR, MLX, CES, or CER), this button launches the 802.1ag CFM
configuration dialog box.
•
Virtual Port IP — Launches the IP Address dialog box, which allows you to add an IP address to
a Switch Virtual Interface (SVI) on DCB products (also known as a Virtual Routing Interface).
•
Deployments — Launches the Deploy VLANs dialog box and displays only saved VLAN and STP
deployments.
•
Manage — Launches the Manage VCS Virtual Fabric dialog box (refer to
VLAN management in a VCS environment
lists the VLAN management features that are supported in VCS mode (Fabric mode),
logical chassis mode, and standalone mode.
TABLE 133
VLAN management features supported for VCS mode
Feature
VCS (FC mode)
Logical chassis mode
Standalone mode
VLAN topology
Yes (shown at the fabric level)
Yes
Yes
STP topology
No
No
Yes
VLAN Manager
Yes (shown at the fabric level)
Yes
Yes
STP views
No
No
Yes
VLAN reports
Yes
Yes
Yes
STP reports
No
No
Yes