Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1469)

Brocade Network Advisor SAN + IP User Manual 1397
53-1003155-01
Product configuration templates
34
Product configuration templates
You can create, modify, duplicate, delete, verify, and deploy a product configuration from the CLI
Configuration dialog box. Product configurations allow you to create device configuration by
entering a set of configuration CLI commands. To view a list of existing configurations, refer to
“Viewing existing templates” on page 1396. For information about the example templates, refer to
“CLI Templates” on page 2221.
Creating a new product configuration
To create a new configuration, complete the following steps.
1. Select Configure > CLI Configuration.
The CLI Configuration dialog box displays.
2. Click Add.
The CLI Template dialog box displays.
FIGURE 626 CLI Template dialog box - Definition tab
3. Click the Definition tab and enter a name and description for the new configuration.
NOTE
Do not use special characters in the name.
a. Enter a name and description for the new configuration.
b. Select Configuration to create a product configuration.
c. To change CLI credentials, click Change Template Credentials and refer to “Changing
product credentials” on page 1402.