Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1949
Brocade Network Advisor SAN + IP User Manual
1877
53-1003155-01
Adding a configuration policy manager
47
NOTE
You can use the All Fabrics and All SAN Switches targets (under the Product Groups >
System Product Groups node) in the Available Switches/Routers list) for future
provisioning. Select All Fabrics and click the right arrow button to apply this policy to all
discovered fabrics. Select All SAN Switches and click the right arrow button to apply this
policy to all discovered switches.
The selected switches display in the Selected Switches/Routers list.
8. To set configuration policy managers for hosts, select the Host Checks tab (
Figure 839
) and
complete the following steps.
FIGURE 839
Add Configuration Policy Manager dialog box, Hosts Checks tab
a. Select the Check for redundant connections to attached fabrics check box to determine if
there are at least the minimum number of configured physical connections between the
host and the attached fabric.
The default is 2. For more information about this check and a fix for rule violations, refer to
“Host configuration policy managers”
b. Enter the minimum number of connections between the host and the attached fabric in
the Minimum Connections field.
The default is 2.
c. Select the Check for connections through two fabrics to each target LUN check box to
determine if there are redundant connections between the host group and the target LUN.
For more information about this check and a fix for rule violations, refer to