Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1600)

1528 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
802.1ag Connectivity Fault Management
37
• Select the Peer Topology tab and right-click a device in the topology and select
802.1ag CFM.
- From the VLL Manager dialog box, Views tab, select an instance from the VLL Instances
table and click 802.1ag CFM.
- From the VLAN Manager dialog box - VLAN View or Product View, select a VLAN from list
and click 802.1ag CFM.
The Configure 802.1ag CFM dialog box displays.
2. Select the maintenance association in the Maintenance Association Details list.
The MEPs associated with the maintenance association display in the Maintenance End Points
(MEP) table:
• The product on which the MEP is located
• The VLAN ID of the MEP
• The port of the MEP
• The user-defined end-point identifier of the MEP
• The direction (up or down) of the MEP
3. Use the dialog box to perform any of the following tasks:
• To add a MEP to a maintenance association, refer to “Adding a MEP to a maintenance
association” on page 1523.
• To edit a MEP, refer to “Editing a MEP” on page 1525.
• To delete a MEP to a maintenance association, refer to “Deleting a maintenance
association” on page 1528.
• To check the status of all remote MEPs for the selected MEP, refer to “Checking the
connectivity status of remote MEPs” on page 1529.
• To send a loopback message to a specific MEP or MIP in the domain, refer to “Sending a
loopback message” on page 1530.
• To send a linktrace message to a specific MEP or MIP in the domain, refer to “Sending a
linktrace message” on page 1531..
4. Click Close on the Configure 802.1ag CFM dialog box.
Deleting a maintenance association
You can access 802.1ag CFM from the following features:
• VPLS Manager (requires the IP - MPLS – VLL prvilege with read-write or read-only permission)
• VLL Manager (requires the IP - MPLS – VPLS prvilege with read-write or read-only permission)
• VLAN Manager (requires the VLAN Manager prvilege with read-write or read-only permission)
NOTE
802.1ag CFM is only supported on IronWare Ethernet Routers devices running firmware release 5.2
or later.
NOTE
Only maintenance domains that are not linked to other associations will be deleted.