beautypg.com

Predefined conditions – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual

Page 1965

background image

Brocade Network Advisor SAN + IP User Manual

1893

53-1003155-01

Configuration rules

47

5. Select the user-defined condition you want to edit and click Edit.

The Edit Condition dialog box displays.

6. Change the user-defined name for the rule in the Name field, if necessary.

The name must be unique. The name cannot be over 128 characters. The only special
character allowed is an underscore (_).

7. Change the description of the rule in the Description field, if necessary.

The description cannot be over 1, 024 ASCII characters.

8. To edit a configuration condition, repeat

step 8

through

step 13

of

“Adding a configuration

condition”

on page 1890.

9. Click OK on the Edit Condition dialog box.

10. Click OK on the Edit Configuration Rule dialog box.

11. Click OK on the Edit Monitor dialog box.

The updated configuration policy manager displays in the Monitors table.

12. Click Close on the Configuration Policy Manager dialog box.

Predefined conditions

The Management application provides predefined conditions.

Table 169

lists the predefined

conditions that can be used in a block or at the configuration rule level. For example, interface
conditions should be used in a port or LAG interface block and SNMP conditions can be used at the
rule level.

TABLE 169

Predefined conditions

Name

Description

Use
regular
expression

Matches/
Not Matches

Configuration

Lines in
exact
order

Network OS Interface shutdown check Checks whether the interface is

configured as shutdown. This
condition should be used within an
interface block.

No

Matches

shutdown

No

Network OS Interface NOT shutdown
check

Condition test fails if the interface is
shutdown.

No

Not Matches shutdown

No

Network OS Interface sflow Enabled
check

Checks whether sFlow is enabled on
the interface. This condition should
be used within an interface block.

No

Matches

sflow enable
sflow sample-rate
32768

Yes

Network OS Interface All VLANs check Checks whether the interface is

configured to be part of all VLANs.
This condition should be used within
an interface block.

No

Matches

switchport trunk
allowed vlan all

No

Network OS Interface Trunk mode
check

Checks whether the interface is
configured to be in trunk mode. This
condition should be used within an
interface block.

No

Matches

switchport
switchport mode
trunk

Yes