Adapter port wwn virtualization, Configuring fawwns on switch ports, Editing a port configuration – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 853: Duplicating a port configuration, Deleting a port configuration
Brocade Network Advisor SAN + IP User Manual
781
53-1003155-01
Adapter port WWN virtualization
19
Editing a port configuration
The Edit Port Configuration dialog box allows you to modify port configuration parameters that were
configured using the Add Port Configuration dialog box.
1. Click Edit on the Configure Host Adapter Ports dialog box.
The Edit Port Configuration dialog box displays.
2. Modify the parameters that are described in
3. Click OK to save the changes.
Duplicating a port configuration
1. Click Duplicate on the Configure Host Adapter Ports dialog box.
The Duplicate Port Configuration dialog box displays. The default name of the configuration file
is source_name copy1.
2. Change the name of the configuration and click OK to save the changes.
Deleting a port configuration
1. Select a configuration from the Port Configuration list in the Configure Host Adapter Ports
dialog box.
2. Click the Delete button.
The port configuration is removed from the list.
Adapter port WWN virtualization
Adapter port world wide name (WWN) virtualization enables the adapter port to use a
switch-assigned WWN rather than the physical port WWN for communication, allowing you to
preprovision the server with the following configuration tasks:
•
Create the zones with the Fabric Assigned WWN (FAWWN) before the servers and devices are
connected to the switches, before they are exposed to the SAN network.
•
Create LUN mapping and LUN masking without the devices present in the network.
•
Preconfigure boot LUN zoning. You can configure Solaris ports or Linux ports on the switch,
enabling the server to boot automatically with the predefined boot LUNs.
NOTE
Fabric Assigned WWN (FAWWN) is not supported for base switches or FICON-enabled switches.
Configuring FAWWNs on switch ports
The Configure Fabric Assigned WWNs dialog box, shown in
Figure 308
, enables you to perform the
following tasks:
•
Enable and disable the Fabric Assigned WWN feature status on a switch or Access Gateway
port.