Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 281
Brocade Network Advisor SAN + IP User Manual
211
53-1003155-01
Software Configuration
5
FIGURE 81
Options dialog box (Memory Allocation pane)
3. (Enterprise only) In the SAN Network Size list, complete the following steps.
For other editions, the SAN Network size is small. You cannot change the SAN Network size.
NOTE
The SAN + IP version is not supported on a 32-bit Windows system.
a. Select the size of the SAN (small, medium, or large) you want to configure.
Product and port recommended counts change to the new default values when you
change the SAN Network size. Recommended counts are as follows:
•
Small SAN — 40 products, 2,000 ports
•
Medium SAN — 90 products, 5,000 ports
•
Large SAN — 200 products, 15,000 ports
NOTE
For full performance management and dashboard functionality, the Large option of the
SAN Enterprise edition only supports 5000 switch ports on a 32-bit system.
Memory and asset polling values change to the new default values when you change the
SAN Network size. You may increase these values. For default values, refer to
and
b. Click OK on the confirmation message.
4. (Enterprise only) In the IP Network Size list, complete the following steps.