Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 882)

810 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
DCB configuration
20
Editing a DCB switch
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the DCB switch from the Products/Ports list.
3. Click Edit.
The Edit Switch dialog box displays ( Figure 316 ).
FIGURE 316 Edit Switch dialog box
4. Configure the policies for the Edit Switch dialog box tabs, which are described in the following
sections:
• “QoS configuration” on page 816
• “FCoE provisioning” on page 823
• “VLAN classifier configuration” on page 825
• “LLDP-DCBX configuration” on page 829
• “802.1x authentication” on page 832
5. When you have finished configuring the policies, apply the settings to the switch.
NOTE
Clicking Cancel when there are pending changes launches a pop-up dialog box.
6. Click OK.
The Deploy to Products dialog box displays.
7. Click OK after changing the attributes of the current deployment.
The Deployment Status dialog box launches.