Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1488)

1416 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Monitoring configurations
34
5. Click the CLI Command tab and complete the following steps.
FIGURE 634 CLI Template dialog box - CLI Commands tab
d. Enter the show commands in the CLI Commands text area.
NOTE
Only commands listed in the cliShowCommands.properties file can be entered for a
monitoring configuration. For more information, refer to
“Configuration error checking” on
page 1411.
For a list of guidelines to use when entering CLI commands, refer to “CLI command
guidelines” on page 1405.
Add commands from the CLI templates or examples by selecting one or more commands
from the CLI Templates or Examples of CLI Commands folder and clicking the right arrow
button. For more information, refer to
“CLI Templates” on page 2221.
e. To enter a parameter for a CLI command, select the parameter type from the CLI
Commands list - Parameters folder and click the right arrow to move the parameter type to
the CLI Commands text area.
Parameters use the following format: $<name|data_type>, where name is the parameter
and data_type is the type of parameter.
Parameter types include integer ($), string ($),
slot/port ($), MAC address ($), and IP address
($).