Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 977)

Brocade Network Advisor SAN + IP User Manual 905
53-1003155-01
Layer 3 access control list policy
22
• To select a network, select IP Address and choose a network from the list.
• To enter a host name, select Host and enter the destination host name on which the ACL
filters traffic in the Host list and text field.
8. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
9. Select the Log Enable check box to enable logging.
10. Click Advanced Settings to configure additional settings for the ACL configuration.
NOTE
You must configure advanced settings to create an extended Layer 3 ACL.
The L3 ACL Advanced Settings dialog box displays.
FIGURE 350 Add - L3 Advanced Settings dialog box (IPv6)
To configure additional settings, refer to “Configuring L3 ACL advanced settings” on page 912.
11. Click the right arrow button.
The new ACL displays in the ACL Entries list.
12. Repeat step 4 through step 11 to add additional entries.
13. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.
14. View the advanced settings for an ACL by selected the ACL in the ACL Entries list and clicking
View.
The L3 ACL Advanced Settings dialog box displays.
15. Click Close on the L3 ACL Advanced Settings dialog box to close.
16. Click OK on the Add - L3 ACL (IPv 6) Configuration dialog box.
The new ACL displays in the ACLs list.
17. To set the configuration type and operations, refer to “Configuring the ACL configuration type
and operations” on page 911.
18. (Ethernet routers only) To set the hit statistics duration, refer to “Configuring hit statistics” on
page 911.
19. To deploy the configuration, click OK on the Device_Name - L3 ACL Configuration dialog box.