Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1213)

Brocade Network Advisor SAN + IP User Manual 1141
53-1003155-01
Rekeying all disk LUNs manually
25
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 376 on page 976.)
2. Select an encryption group from the Encryption Center Devices table, then select Group >
Re-Key Sessions from the menu task bar.
The Re-Key Sessions Status dialog box displays, which enables you to check on the status of
each LUN that is being rekeyed within an encryption group. (Refer to
Figure 517 .)
FIGURE 517 Re-Key Sessions Status dialog box
The dialog box contains the following information:
• LUN #: The LUN number.
• LUN Serial #: The LUN serial number.
• Re-Key Session #: The number assigned to the rekeying session.
• Percent Complete: The percentage of completion of the rekeying session.
• Re-Key State: Options are:
- Re-Key Setup
- LUN Prep
- LUN Clean-up
- Key Update
- Read Phase
- Write Phase
- HA Sync Phase
• Re-Key Role: Options are:
- Primary/Active
- Backup/Active
• Block Size: The block size used on the LUN.
• Container Name: The CryptoTarget container name.
• Host Port WWN: The WWN of the host port that is being used for the write operation.
• Current LBA: The Logical Block Address (LBA) of the block that is currently being written.
• Number of Blocks: The number of blocks written.