Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 2220
2148
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
RASLog Events
C
CONF-1031
LOG
configDefault completed successfully.
CONF-1032
LOG
configRemove completed successfully.
CONF-1042
LOG | AUDIT
Indicates that the fabric configuration parameter value has been changed.
CONF-1043
LOG | AUDIT
Indicates that the fabric configuration parameter value has been changed.
CONF-1044
LOG | AUDIT
Indicates that the fabric configuration parameter value has been changed
by a user.
FABR-1016
LOG
FICON mode enabled.
FABR-1017
LOG
FICON mode disabled.
FABR-1030
LOG
Domain ID changed
FCR-1005
LOG
Indicates that a device is removed from the logical storage area network
(LSAN) zone in the edge fabric.
FCR-1006
LOG
Indicates that a device is added to a logical storage area network (LSAN)
zone in the edge fabric.
FCR-1007
LOG
Indicates that a logical storage area network (LSAN) zone attached to the
specified port was deleted in the edge fabric.
FCR-1008
LOG
Indicates that a logical storage area network (LSAN) zone was created at
the specified port in the edge fabric.
FCR-1009
LOG
Indicates that a logical storage area network (LSAN) zone was enabled in
the edge fabric attached to the specified port. The enabled LSAN zone
configuration is listed.
FCR-1010
LOG
Indicates that a logical storage area network (LSAN) zone is disabled in the
edge fabric attached to the specified port.
FCR-1011
LOG
Indicates that a logical storage area network (LSAN) zone update was
received from another domain.
FCR-1015
LOG
Indicates that an EX_Port was created on the specified port in the specified
domain.
FCR-1016
LOG
Indicates that a fabric is no longer accessible through the backbone fabric.
This may be caused by a link or switch failure.
FCR-1034
LOG
LSAN zone added in backbone fabric.
FCR-1035
LOG
LSAN zone device <device WWN> added in the backbone fabric.
FCR-1036
LOG
LSAN zone <zone name> enabled in the backbone fabric.
FCR-1037
LOG
LSAN zone disabled in the backbone fabric.
FCR-1061
LOG
Backbone fabric created on a port
FCR-1068
LOG
FCR disabled.
FCR-1069
LOG
FCR enabled.
FCR-1071
LOG
Port is changed from non-FCR port to FCR port.
FCR-1072
LOG
Port is changed from FCR port to non-FCR port.
FCR-1088
LOG
LSAN <Enforce/Speed> tag <Tag Name> added.
FCR-1089
LOG
LSAN <Enforce/Speed> tag <Tag Name> removed.
FCR-1091
LOG
Backbone Fabric ID changed to <Tag>.
TABLE 217
Configuration change events (Continued)
Event ID
Type
Description