Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 968
896
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Layer 3 access control list policy
22
FIGURE 347
Add - L3 ACL Configuration (Standard) dialog box
3. Select Standard from the Type list.
4. Enter a name or number for the ACL in the ACL Name/Number field.
5. Select Permit or Deny from the Action list.
6. Enter a description for the ACL in the Remarks field.
7. Choose one of the following options from the Source list:
•
To enter an IP address, select IP Address and complete the following steps:
a. Enter the source IP address on which the ACL filters traffic in the IP Address list and
text field.
b. Enter a portion of the source IP address on which the ACL filters traffic in the Wildcard
Mask field.
The wildcard mask is a four-part value in IP address format consisting of ones and
zeros. Use zeros in the mask if the packet source address must match the IP address.
Use ones if to match any value.
For example, if you enter ‘209.157.22.26’ in the IP Address field and ‘0.0.0.255’ in
the Wildcard Mask field, then all hosts in the Class C subnet ‘209.157.22.x’ match the
ACL.
•
To select a network, select IP Address and choose a network from the list.
To configure a network, click the ellipsis button and refer to
•
To enter a host name, select Host and enter the source host name on which the ACL filters
traffic in the Host list and text field.
8. Enter a VLAN identifier (valid values are from 1 to 4095) from the VLAN list.
9. Select the Log Enable check box to enable logging.
10. Click the right arrow button.
11. Use the Up and Down arrow buttons to rearrange the ACLs in the ACL Entries list.