Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 741)

Brocade Network Advisor SAN + IP User Manual 669
53-1003155-01
Ports
14
FIGURE 277 Port Connectivity View dialog box
The following details the information located (in default order) on the Port Connectivity View dialog
box.
• Fabric / Switch Name — If launched from a fabric, displays the fabric name. If launched from a
switch, displays the fabric name and the switch name.
• Filter check box / link — Select to filter results (refer to “Filtering port connectivity” on
page 672) in the Port Connectivity View dialog box.
• un-named list — Select to view port connectivity for all switches in the fabric or a specific
switch. Default selection is All Switches.
• Refresh button — Click to refresh the dialog box.
• Add Flow button — Select a port and click to add a flow definition (refer to “Flow Monitor” on
page 1737).
NOTE
Flow Vision is supported on platforms running Fabric OS 7.2 and later.
• Port connectivity table — Displays the ports connected to the selected fabric or device. Loop
devices are displayed in multiple rows, one row for each related device port. If no switch or
device is connected to the port, then the related fields are empty.
- Port Number — The port’s number. To enable or disable a port, refer to “Enabling a port”
on page 672 or “Disabling a port” on page 672.
- Blade Number — The number of the blade.
- Port Name — The port’s name.
- Switch — The switch name.
- User Port Number — The port number of the user’s device.