Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1702)

1630 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
SAN Top Talker monitoring
43
The Top Talker Selector dialog box displays, as shown in Figure 732 on page 1630.
FIGURE 732 Top Talker Selector dialog box
3. Select Fabric in the Top Talker Mode list to select a switch to monitor.
4. Select an available switch from a fabric in the left panel, and then the right arrow to move it to
the right panel.
You can select only one device on which to enable Top Talkers.
5. Click OK on the Top Talker Selector dialog box.
Top Talkers is enabled on the selected device. The Top Talkers - Fabric Mode for Device_Name
dialog box displays.
6. Select the number of Top Talkers (1 through 20) to display from the Display list.
7. Select how often you want the Top Talker to refresh (10, 20, 30, 40, or 50 seconds, or 1
minute) from the Refresh Interval list.
8. Click Apply.
The top 20 conversations display in the Current Top Talkers list. The Top Talkers Summary list
displays all Top Talkers that occurred since the Top Talkers - Fabric Mode for Device_Name
dialog box was opened (displays a maximum of 360). When the maximum is reached, the
oldest Top Talker drops as a new one occurs.
The fabric mode Top Talker provides the following details:
8. Click Destination to launch the Port Properties dialog box for the Destination port.
9. Click Source to launch the Port Properties dialog box for the Source port.
•
Tx+Rx Ave (MB/sec)
•
Last Occurred
•
Occurrences
•
SID
•
Source
•
Source Port
•
Source Switch/Port
•
DID
•
Destination
•
Destination Port
•
Destination Switch/Port