Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 282)

212 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Software Configuration
5
For other editions, the IP Network size is medium. You cannot change the IP Network size.
a. Select the size of the IP Network (small, medium, or large) you want to configure.
Product recommended counts change to the new default values when you change the IP
Network size. Recommended counts are as follows:
• Small — 20 products (recommended)
• Medium — 200 products (recommended)
• Large — 5,050 products (recommended)
Memory and asset polling values change to the new default values when you change the
IP Network size. You may increase these values. For default values, refer to
step 5 and
step 6 .
b. Click OK on the confirmation message.
5. Enter the memory allocation (MB) for the client in the Client Memory Allocation field.
If you enter an invalid value, an error message displays with the minimum value allowed. Click
OK and edit the value again.
The current configured number of megabytes for client memory allocation displays in the
Current Value field. The default minimum number of megabytes for client memory allocation
displays in the Default Minimum field.
For all network sizes, the default minimum Client Heap Size is 950 MB.
NOTE
There is no restriction on the Client Heap Size value. The correct Client Heap Size value should
be given according to the RAM present in the server when it is launched.
NOTE
For a 32-bit server, configuring a value higher than 1024 MB impacts the client launch.
6. Enter the memory allocation (MB) for the server in the Server Memory Allocation field.
If you enter an invalid value, an error message displays with the minimum value allowed. Click
OK and edit the value again.
The current configured number of megabytes for server memory allocation displays in the
Current Value field. The default minimum number of megabytes for server memory allocation
displays in the Default Minimum field. The IP address of the server displays in the Server IP
field. The server name displays in the Server Name field.
To support more than 8 clients on a 64-bit server, increase the memory allocation for the
server to 3076 MB.
Default values for SAN + IP Server:
TABLE 26 Server heap size for 32-bit Linux Server
Small LAN Medium LAN Large LAN
Small SAN Enterprise 768 MB 1024 MB 1200 MB
Medium SAN Enterprise 1024 MB 1024 MB 1400 MB
Large SAN Enterprise 1200 MB 1400 MB 1500 MB