Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1456)

1384 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Payloads
33
Payloads
Payloads are defined as product payloads or interface payloads. Product payloads are deployed to
the devices, whereas interface payloads are deployed to ports.
The available payloads are listed in Table 129 .
TABLE 129 Payloads available for deployment
Payload name Description
Product Payloads:
802.1Q Tag Type Sets the tag type, or tag ID, that identifies the aggregate VLAN.
Banners Displays messages when a user logs in to a device at a Privileged EXEC CLI
level, or when a user accesses a device using Telnet or Secure Shell.
Boot Sequence Specifies the sources from which the device will boot.
CLI Configuration Deploys CLI configuration definitions that have been created in the CLI
Configuration Manager to wired devices.
CLI Product Monitoring Deploys CLI product monitoring definitions that have been created in the CLI
Configuration Manager to wired devices.
DNS Defines a domain that serves as a gateway to the DNS (Domain Name Server).
DNS Name Search List Creates a list of DNS names and adds, deletes, or replaces target products that
match the names in the list.
Enable Passwords Assigns passwords to management privilege levels on the IOS device.
FDP Settings Enables IOS devices to advertise themselves to other IOS devices on the
network.
Image Update: Boot Deploys boot and monitor images to devices.
Image Update: Software Updates the software image file on a device.
Firmware Image Update:
Unified Updates the unified firmware image file on a device.
LDP Settings Configures LDP settings on a product.
Protocols Enables or disables routing protocols on devices.
This payload cannot be deployed to non-IP IOS devices.
RADIUS Parameters Specifies the number of times an IOS device can resend an authentication
request and wait for a response from the RADIUS server.
RADIUS Servers Indicates which RADIUS servers are used for authentication.
Reload Products Reloads selected products at one time.
SNMP Community Strings Configures SNMP v1 and V2 community strings.
SNMP Identification Sets the contact, location, and system name information about a product.
SNMP Trap Enable Configures which standard traps are sent to trap receivers by the product.
SNMP Trap Receivers Defines the trap receivers for a product.
SNMP V3 Settings Defines the user accounts that can access the product using SNMP v3.
Syslog Receivers Defines the systems that have been identified to receive system log events.
TACACS+ Parameters Configures the TACACS/TACACS+ retransmit, timeout, and dead time
authentication parameters.